Herb and Garlic Crusted New York Strip Roast

Adapted recipe by simplecomfortfood
Photo by Robert P.

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

Ingredients

  • 7

    lb New York Strip Roast

  • 7

    cloves of garlic

  • 3

    tbsp fresh thyme leaves

  • 2

    tbsp fresh rosemary leaves

  • 10

    fresh sage leaves

  • 1/3

    cup of olive oil

  • 1 1/2

    tbsp salt

  • 1

    tbsp cracked black pepper

Directions

Start by adding the garlic and herbs to food processor. Pulse to break down all of those ingredients into a workable garlic and herb paste. Add a bit of oil if things are getting stuck, or turn it off, remove the lid, and stir the herbs, continuing to pulse until everything is finely chopped. Once finely chopped, remove the blade from the food processor, then add in the oil, salt, and pepper. Scrape everything, and get a nice paste out of this mixture. Unwrap the beef, and rub that paste all over the beef. Make sure you get the top, bottom, and sides. Wrap the beef back up in the butcher paper, seal it, and place in the refrigerator overnight. When you are ready to cook the beef, take it out of the refrigerator, and let it rest on the kitchen counter for at least one hour. You want the beef to come up to room temperature. Set the beef onto a roasting rack, into a roasting pan. Preheat your oven to 450 degrees. Your goal here is to blast the beef on high heat to start a nice crust, then we will reduce the heat and continue cooking until it reaches the temperature you like your meat, in my case, a medium rare. So once your oven is preheated, place the roasting pan into the oven, and cook at 450 for 20 minutes. After 20 minutes, reduce the heat to 350 degrees. Cook until you have reached an internal temperature (use a meat thermometer) of 127 degrees, or so. When you pull it out and let the meat rest, the internal temperature will rise, and should get you into the 130-135 degree range where it is medium rare. If you want your meat medium, let it go to 140-145 degrees. Remove the meat, and let it rest, tented with aluminum foil, for at least 15-20 minutes. Once rested, move the beef onto a cutting board, and slice into your desired thickness.

Keyingredient.com uses 'cookies' to give you the best, most relevant experience. Using this website means you're ok with this. You can change which cookies are set at any time and find out more about them by following this link.

Please describe your issue: