Herb-and-Salt-Crusted Standing Rib Roast

By abrocakes

Ingredients

• 2 cups kosher or sea salt
• 1 large egg white
• 3 Tbs. freshly ground black pepper
• 3 Tbs. chopped fresh thyme (stems included)
• 2 Tbs. chopped juniper berries
• 2 Tbs. chopped garlic
• 1 Tbs. chopped fresh flat-leaf parsley
• 2 to 3 cups unbleached all-purpose flour; more for rolling
• One 3-bone standing beef rib roast (about 7 lb.), cut from the loin end, chine bone and fat cap removed
• 1 Tbs. vegetable oil

Preparation

Step 1

In a stand mixer fitted with the paddle attachment, combine 1 cup water with the salt, egg white, pepper, thyme, juniper, garlic, and parsley. Mix on medium speed until blended. On medium-low speed, mix in 2 cups of the flour, adding more as needed, until the dough is firm and feels slightly dry and stiff, like Play-Doh. Continue to mix for 2 minutes. The dough should be smooth and firm but not sticky; add more flour if necessary. Flatten the dough into a rectangle, wrap in plastic, and refrigerate for at least 2 hours and up to 6 hours.

An hour before you’re ready to roast, put the beef on the counter and let sit at room temperature.

Position a rack in the center of the oven and heat the oven to 350°F. Heat a large cast-iron skillet over medium-high heat. Add the oil and put the roast meat side down in the skillet; sear until deeply browned, about 5 minutes. Remove the roast from the pan and set it bone side down on a rack in a roasting pan.

On a lightly floured surface, roll the dough into a 1/4-inch-thick rectangle. Drape the dough over the meat, tucking it in on all sides. Roast until an instant-read thermometer in the middle of the roast registers 125°F for rare or 135°F for medium rare, 1-3/4 to 2-1/4 hours. Let rest for 20 minutes, then remove and discard the crust. (After removing the crust, the roast can rest for up to 30 minutes more.)