Pumpkin Bread

Photo by PineyCook
Adapted from onceuponachef.com

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

Adapted from onceuponachef.com

Ingredients

  • 2

    cups all-purpose flour, spooned into measuring cup and leveled-off, plus more for greasing the pan

  • 1/2

    teaspoon salt

  • 1/2

    teaspoon baking powder

  • 1

    teaspoon baking soda

  • 1

    teaspoon ground cloves

  • 1

    teaspoon cinnamon

  • 1

    teaspoon ground nutmeg

  • 2

    cups sugar

  • 1-1/2

    sticks (3/4 cup) unsalted butter, softened, plus more for greasing the pan

  • 2

    large eggs

  • 1

    15-ounce can 100% pure pumpkin (I use Libby's)

Directions

Preheat oven to 325 degrees. Generously grease two 8 ½” x 4 ½” loaf pans with butter and dust with flour (or use a baking spray with flour). Combine flour, salt, baking powder, baking soda, and spices in a bowl; use a whisk to mix well and set aside. In large bowl of an electric mixer, at medium speed, beat butter and sugar until just blended. Add eggs one at a time, beating well after each addition. Continue beating until very light and fluffy, a few minutes. Beat in pumpkin. The mixture might look grainy and curdled at this point -- that's ok. At low speed, beat in flour mixture until well combined. Turn batter into prepared pans, dividing evenly, and bake for 65 – 75 minutes, or until cake tester inserted in center comes out clean. Let loaves cool in pan about 10 minutes, then turn out on wire rack to cool completely. (If the loaves stick, run a plastic knife around the edges of the pan to loosen them.) Fresh out of the oven,the loaves have a deliciously crisp crust. If they last beyond a day, you can toast individual slices to get the same fresh-baked effect.

Keyingredient.com uses 'cookies' to give you the best, most relevant experience. Using this website means you're ok with this. You can change which cookies are set at any time and find out more about them by following this link.

Please describe your issue: