Atkins Coconut Layer Cake

Atkins Coconut Layer Cake
Atkins Coconut Layer Cake

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

12

servings

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

12

servings

Ingredients

  • 8

    eggs

  • 3/4

    cup sugar substitute (such as granular Splenda)

  • 1

    tablespoon coconut extract

  • 2/3

    cup Atkins Bake Mix

  • 1/2

    cup unsalted butter melted, cooled

  • 6

    egg whites

  • 3/4

    cup sugar substitute

  • 1/4

    teaspoon salt

  • 1 1/2

    cups unsalted butter softened

  • 2/3

    cup unsweetened shredded coconut

Directions

Heat oven to 350 degrees. Grease two 8-inch cake pans; line bottoms with parchment paper; grease again. With an electric mixer on high, beat eggs, sugar substitute, and extract until ribbons form, about 5 minutes. In three additions sift bake mix over egg mixture; fold in with a rubber spatula to combine. Fold in butter. Pour batter into prepared pans. Bake 22 minutes until cake springs back in middle when lightly touched. Cool in pans on wire racks 5 minutes. Line racks with paper towels and invert cake layers. Gently peel off parchment. Cool completely. For frosting: In a double boiler or a bowl placed over simmering water, whisk egg whites, sugar substitute and salt until temperature reaches 130 degrees. Transfer whites to mixing bowl and beat on high speed until cool. Reduce speed to medium and beat in butter until well combined. Place one cake layer on serving plate. Mix 1 cup frosting with half the coconut; frost bottom layer. Place top cake layer over bottom layer. Cover top and sides with remaining frosting. Pat remaining coconut over frosting. This recipe yields 12 servings. Carbohydrates: 6.5 grams Net Carbs: 5.5 grams Fiber: 1 grams Protein: 7.5 grams Fat: 37 grams Calories: 404

Keyingredient.com uses 'cookies' to give you the best, most relevant experience. Using this website means you're ok with this. You can change which cookies are set at any time and find out more about them by following this link.

Please describe your issue: