Rigatoni with Beef and Onion Ragu

If marjoram is unavailable, substitute an equal amount of oregano. Pair this dish with a lightly dressed salad of assertively flavored greens.

Rigatoni with Beef and Onion Ragu
Rigatoni with Beef and Onion Ragu

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

--

servings

Ingredients

  • 1

    (1- to 1 1/4-pound) boneless beef chuck-eye roast, cut into 4 pieces and trimmed of large pieces of fat

  • Kosher salt and pepper

  • 2

    ounces pancetta, cut into 1/2-inch pieces

  • 2

    ounces salami, cut into 1/2-inch pieces

  • 1

    small carrot, peeled and cut into 1/2-inch pieces

  • 1

    small celery rib, cut into 1/2-inch pieces

  • 2 1/2

    pounds onions, halved and cut into 1-inch pieces

  • 2

    tablespoons tomato paste

  • 1

    cup dry white wine

  • 2

    tablespoons minced fresh marjoram

  • 1

    pound rigatoni

  • 1

    ounce Pecorino Romano cheese, grated (1/2 cup), plus extra for serving

Directions

1. Sprinkle beef with 1 teaspoon salt and 1/2 teaspoon pepper and set aside. Adjust oven rack to lower-middle position and heat oven to 300 degrees. 2. Process pancetta and salami in food processor until ground to paste, about 30 seconds, scraping down sides of bowl as needed. Add carrot and celery and process 30 seconds longer, scraping down sides of bowl as needed. Transfer paste to Dutch oven and set aside; do not clean out processor bowl. Pulse onions in processor in 2 batches, until 1/8- to 1/4-inch pieces form, 8 to 10 pulses per batch. 3. Cook pancetta mixture over medium heat, stirring frequently, until fat is rendered and fond begins to form on bottom of pot, about 5 minutes. Add tomato paste and cook, stirring constantly, until browned, about 90 seconds. Stir in 2 cups water, scraping up any browned bits. Stir in onions and bring to boil. Stir in 1/2 cup wine and 1 tablespoon marjoram. Add beef and push into onions to ensure that it is submerged. Transfer to oven and cook, uncovered, until beef is fully tender, 2 to 2 1/2 hours. 4. Transfer beef to carving board. Place pot over medium heat and cook, stirring frequently, until mixture is almost completely dry. Stir in remaining 1/2 cup wine and cook for 2 minutes, stirring occasionally. Using 2 forks, shred beef into bite-size pieces. Stir beef and remaining 1 tablespoon marjoram into sauce and season with salt and pepper to taste. Remove from heat, cover, and keep warm. 5. Bring 4 quarts water to boil in large pot. Add rigatoni and 2 tablespoons salt and cook, stirring often, until just al dente. Drain rigatoni and add to warm sauce. Add Pecorino and stir vigorously over low heat until sauce is slightly thickened and rigatoni is fully tender, 1 to 2 minutes. Serve, passing extra Pecorino separately. TECHNIQUE SCIENCE: A SURPRISING FORMULA FOR MEATY FLAVOR Believe it or not, much of the meaty flavor in our Genovese ragu actually comes from the 2 1/2 pounds of onions in our recipe. Specifically, the flavor stems from a compound in onions called 3-mercapto-2 methylpentan-1-ol, or MMP for short. When an onion is cut, some of its sulfur compounds combine to form a new compound: propanethial-S-oxide—the stuff that makes your eyes tear. When heated, this compound turns into MMP. And what does MMP taste like? Meat broth. To harness MMP's full savory power, we switched from slicing to finely chopping the onions in a food processor to create even more opportunities for sulfur compounds to be released and transformed into MMP. But there’s a hitch: MMP's flavor is water-soluble, which means that to create it, water must be present. And the more water the more beefy flavor that’s extracted. By cooking the onions and meat in 2 cups of water (versus allowing them to simmer in their own juices), we were able to create a marked increase in meaty flavor.

Keyingredient.com uses 'cookies' to give you the best, most relevant experience. Using this website means you're ok with this. You can change which cookies are set at any time and find out more about them by following this link.

Please describe your issue: