Country Fried Steak With White Gravy

Country Fried Steak With White Gravy
Country Fried Steak With White Gravy

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

4

servings

PREP TIME

--

minutes

TOTAL TIME

--

minutes

SERVINGS

4

servings

Ingredients

  • 1

    cup vegetable oil

  • 4

    pieces round steak - (4 oz ea)

  • Salt to taste

  • Freshly-ground black pepper to taste

  • 1

    egg beaten

  • 3

    cups milk plus

  • 3

    tablespoons milk

  • 1 1/2

    cups all-purpose flour plus

  • 3

    tablespoons all-purpose flour

Directions

Heat the oil in a heavy 9-inch cast-iron skillet, to 360 degrees. Using a meat mallet, pound out the meat. Season the steak with salt and pepper. Combine the egg with 3 tablespoons of the milk. Put 1 1/2 cups of the flour in a shallow pan and season with salt and pepper. Dredge the steaks in the flour, coating each piece evenly and tapping off any excess. Dip the steak in the egg wash, coating it completely and letting the excess drip off. Dredge again in the flour, shaking off any excess. Fry the steaks in the hot oil, until golden brown on each side, about 3 minutes. Remove and drain on paper towels. Season with salt and pepper. Carefully pour off the oil, leaving behind about 1/4 cup of the oil along with the brown bits. Over medium heat, add the remaining 3 tablespoons flour and cook for 3 to 4 minutes, whisking constantly. Add the remaining 3 cups milk, 1/2 cup at a time, whisking constantly. Bring to a boil, then reduce the heat to medium-low. Season with salt and plenty of pepper. Cook for 8 to 10 minutes, whisking constantly. The gravy should be thick enough to coat the back of a spoon. If it is too thick, add a little water to thin it. Serve the fried steak and gravy with mashed potatoes and green beans. This recipe yields 4 servings.

Keyingredient.com uses 'cookies' to give you the best, most relevant experience. Using this website means you're ok with this. You can change which cookies are set at any time and find out more about them by following this link.

Please describe your issue: